News Center
How to Detect gis substation tanks

How to Detect gis substation tanks

Using Picterra, SEGES was able to detect 26.000 slurry tanks over Denmark in a few hours with only 56 training annotations. This project clearly shows how machine learning models can be used to analyze geospatial imagery at scale, even over the whole country, in a very effective and time-efficient way. – said Julien Rebetez, Lead Software ...

[email protected]
News Detail
  • INNOVA 3731 - SF6 leak detection system for enclosed

    2019-8-1The 3731 system can detect—with a short response time—any excessive increase in the leak rate, enabling It draws air samples from up to 24 locations for maximum coverage of the GIS substation. Tubing lines can easily run into existing control cable trays, or trenches. Analog and alarm relay outputs can be connected to local RTU.

    Get Price
  • An Introduction to Gas Insulated Electrical Substations

    This online engineering course provides a basic overview of Gas Insulated Substations (GIS) and GIS technology. A GIS is a high voltage substation in which the major conducting structures are contained within a sealed environment with a dielectric gas known

    Get Price
  • How to arrive at Conceptual Layout of a GIS substation at

    Conceptual layout (here-onwards mentioned as layout) of the substation is prepared at offer stage to arrive at spatial arrangement of all major equipment of the substation and costing thereof.

    Get Price
  • DEVELOPMENT OF THE REMOTE MONITORING AND

    Methods are also described to detect partial discharge and ground fault location, as well as to monitor display system in the diagnostic system for GIS MTR in 154kV substation. GIS Part 1

    Get Price
  • High Voltage Substation Design Approach - For Utility

    2014-8-20High Voltage Substation Design Approach - For Utility Systems By: Gustavo A. Rodriguez, PE Air Insulated (AIS) Gas Insulated (GIS) Sensitivity – Ability of protective device to detect faults and operate under minimum expected conditions.

    Get Price
  • Press Release: How to detect 26.000 objects on a WMS

    Using Picterra, SEGES was able to detect 26.000 slurry tanks over Denmark in a few hours with only 56 training annotations. This project clearly shows how machine learning models can be used to analyze geospatial imagery at scale, even over the whole country, in a very effective and time-efficient way. – said Julien Rebetez, Lead Software

    Get Price
  • Research of the vibration characteristics in GIS

    Abstract: Because its small size and high reliability, GIS is used more and more widely in substation, so it is very necessary to detect and prevent the faults in the operation. In the actual operation of GIS, there are a large number of accidents caused by mechanical failure except discharge fault detection. And at present the most extensive research on GIS is studying the detection of

    Get Price
  • Using remote sensing and GIS techniques for monitoring

    2018-4-4Remote sensing and GIS provide a historical database from which hazard maps may be generated, indicating which areas are potentially dangerous. The zonation of hazard must be the basis for any environmental risks management project and should supply planners and decision-makers with adequate and understandable information. Introduction

    Get Price
  • Integrated Management for the Handling and Disposal of

    2017-2-9MANOMETERS AT THE GIS PACHACHACA SUBSTATION In the GIS Pachachaca substation the SF6 gas compartments do not have gauges for the visual monitoring of the gas, every month the operator has to install a portable manometer compartment per compartment for reading and monitoring the SF6 gas pressure. Densitymeter for SF6 gas monitoring (blind).

    Get Price
  • Substation physical security and resiliency Checklist for

    2021-2-17substation design modifications and new equipment/substation hardening. Operational measures Operationally there are several elements that can make your substation more secure; perimeter fencing, alarm systems, remote surveillance, lighting, and communication redundancies are all activities that server to deter and detect would-be attack-ers.

edge-iconRelated News
toTop
Click avatar to contact us
Chat Online